Belkin Power Management Software for Linux gives you the ability to shut down, restart, initiate
self-tests and issue other commands to your local UPS.  Just type 
"/etc/upsilon/upsilon issuer" to bring up the screens shown below.  The 
screen displayed would depend on the Belkin Power Management Software configuration.

Belkin Power Management Software CONFIGURED TO MONITOR THE UPS FROM THE SERIAL PORT
	Short Description of Each Option
	[s]	10 Seconds Test  
			UPS performs a 10 seconds self test then 
			returns to utility.
	[b]	Test until Battery Low
			UPS performs self test until battery becomes 
			low.
	[t]	Test for a Specified Time Period
			Specify the duration of Self-Test by using the 
			[+] and [-] keys.  UPS performs Self-Test 
			according to this time setting.
	[n]	Shut Down UPS
			UPS stops providing output power after a few 
			seconds.
	[a]	Cancel Shut Down Command
			Cancels an impending UPS shutdown or turns on 
			the UPS if utility is present.

Belkin Power Management Software CONFIGURED TO MONITOR THE UPS FROM AN SNMP AGENT
	Short Description of Each Option
	[s]	Shut Down UPS
			UPS stops providing output power after a few 
			seconds.
	[c]	Cancel Shut Down Command
			Cancels an impending UPS shutdown. 
	[o]	Turn On UPS
			Turns on the UPS if utility is present.
	[u]	Reboot UPS
			UPS shuts off then turns back on.
	[l]	Put UPS to Sleep
			Specify the duration of sleep using [+] and [-] 
			keys.  UPS will not provide output power while 
			in sleep mode.
	[m]	Simulate Power Fail
			UPS switches to battery power.
	[b]	Conserve Battery
			UPS on battery goes to sleep mode.
	[d]	Diagnostic Self Test
			UPS performs a short diagnostic self test.
	[t]	Test Run Time Calibration
			The UPS discharges it's batteries until 
			capacity is less than 25% 
	[f]	Flash and Beep
			UPS lights all indicators and beeps.
	[I]	Test Indicators
			UPS performs a front panel lights test.
